compound microscope

1. The optical system of a refracting telescope is essentially the same as that of a compound microscope.
   折射望远镜的光学系统与复显微镜的光学系统基本上相同。
2. Compound optical measuring microscope
   复合光学测量显微镜
3. Compound optical phase contrast microscope
   复合光学相衬显微镜酪素-纤维素复合物的电化学异相合成
4. Compound optical reflecting microscope
   复合光学反射显微镜
5. Researchers could dose cells with a potential therapeutic compound and use the microscope to watch their response.
   研究者可以用不同剂量的具有潜在疗效的药物处理细胞，并利用这种显微镜观察处理后细胞的反应。
6. Determining the proportion of compound fibers by microscope
   利用显微镜测定复合纤维组分
7. The crystallization behavior and morphology of the PP compound were investigated by means of differential scanning calorimeter and polarized light microscope.
   用差示扫描量热计和偏光显微镜分析了混合体系的结晶行为和形态。
8. Then the microstructure of the compound layer is observed through the microscope and the X rays diffractometer. In addition the pure sliding wear test has been done with the MPX-200 wear test machine.
   通过金相显微镜和X射线衍射仪观察了化合物层的显微组织和微观结构及在MPX200型盘销式摩擦磨损试验机上进行纯滑动干磨损试验。
9. The structure and morphologies of compound were studied by Fourier transform-infrared spectroscopy, X-ray diffraction 、 energy-dispersion X-ray and scanning electron microscope in rubber mixing and vulcanization process, then the mechanical properties were studied.
   用傅里叶变换红外光谱法、X射线衍射法、能量色散X射线法和扫描电子显微镜法分析了NR在混炼和硫化过程中的结构和形态变化，并研究了硫化胶的力学性能。
10. The Study of the Interfaces between Compound Bioceramics Artificial Bone and Bone By Means of Scanning Electron Microscope and X-ray Energy Spectrum Analysis
    四种窝沟封闭剂渗透性的扫描电镜研究复合生物陶瓷人工骨与骨组织结合界面扫描电镜观察及X线能谱分析
11. Nanocrystalline intermetallic compound CuAl_2 powder was synthesized by flow-levitation method. The microscope structure and phase composition were studied by means of TEM and XRD.
    根据ICF靶材料研究的需要，采用自悬浮定向流法制备了金属间化合物CuAl2纳米复合微粉，并通过TEM和XRD等分析手段对复合微粒材料的显微结构和相组成进行了研究。
12. TIG welding process with TGS-309L super-low carbon austenitic stainless steel welding wire is used on the transitional layer of the weld of20/ 0Cr18Ni9 compound pipes. After welding, the welded joint is analyzed and researched by metallurgical microscope and scanning electron microscope.
    采用TIG焊和超低碳奥氏体不锈钢焊丝TGS-309L焊接20/0Cr18Ni9复合管的过渡层焊缝，焊后利用金相显微镜和扫描电子显微镜对焊接接头进行了分析研究。
13. Mo Si compound composites were synthesized by in situ reaction hot pressing. Their microstructure and phase composition were analyzed by means of scanning electron microscope ( SEM), electron probe microanalyzer ( EPMA) and X ray diffractometer ( XRD).
    采用反应烧结法原位合成了Mo-Si系化合物复合材料，利用X射线衍射仪、扫描电镜和电子探针等考察了材料的显微结构和相组成。
14. Analysis of the lanthanum-substituted hydroxyapatites and HA by FTIR spectroscopy and X-ray diffraction. Methods First to prepare for the HAC/ NVCM compound, then to investigate the compressive strength, setting time, X-ray diffraction and subsurface structure by Scan Electron Microscope ( SEM).
    方法首先形成羟磷灰石骨水泥/去甲万古霉素复合体，然后根据不同的载药量分别测定其抗压强度，凝固时间，并通过X线衍射和扫描电镜分析其固化反应产物和表面结构的变化。
15. Methods Firstly, the injectable composites were compounded with ICPC and FG as volume ratio of 2:1. The crystallizing time and mechanical character of the compound material were measured and their constructions before and post burnt were observed by scanning electron microscope ( SEM).
    方法：首先将ICPC和FG按各自凝固后的体积比为2/1比例均匀混合，制成复合材料。
16. The structure of the compound emulsion is characterized by use of X-ray diffraction ( XRD) and transmission electronic microscope ( TEM). The thermal properties, mechanical performance, water resistance, surface contact angle, and UV stability of the compound emulsion are studied.
    利用X射线衍射（XRD）和透射电子显微镜（TEM）对复合物的结构进行了分析，并对复合物的热性能、力学性能、耐水性能、表面接触角及耐紫外光性能进行了研究。
17. Compound materials SiCp/ ZL201 is prepared by half solid state stir technology and liquid die forging, whose mechanical performance and section form are searched for with optics microscope, SEM, mechanical performance test and section analysis.
    采用半固态搅拌工艺和液态模锻方法制备了SiCp/ZL201复合材料。用光学金相显微镜、扫描电子显微镜和力学性能试验研究了复合材料的显微组织、力学性能和断口形貌特征。
18. The common, particular structure and the arrangement pattern of the retinula in the compound eye of the housefly Musca domestica have been investigated, and the structures of the retinula cells here been compared with an electron microscope under dark, bright and high intensity light adaptation condition.
    用电子显微镜研究了家蝇（Muscadomestica）复眼小网膜的一般结构，特殊结构和小网膜细胞的对称性排列，并比较了在暗适应、明适应和强光适应状态下小网膜细胞的结构。
19. The technology of rolling compound of Al-Cu under room temperature is investigated and the bonding mechanism is discussed by experiments for different the rate of deformation and the temperature of thermal treatment with the help of the optical microscope, mechanical equipment, scanning electron microscope.
    通过不同的压下率和不同的扩散退火温度试验，利用金相显微镜，力学实验机、扫描电镜等仪器，研究在室温条件下铝-铜轧制复合工艺，探讨界面结合机理。
20. The compose and microstructure of intermetallic compound after temperature cycling test are also observed by scanning electron microscope ( SEM).
    通过扫描电镜（SEM）对温度循环试验后焊球金属间化合物（IMC）层和剪切强度试验后的断裂面进行了形貌、结构和组分的观察及分析。
21. Then the tissue of Fe-Al intermetallic compound coating was observed by Metallographic Microscope and Scanning Electron Microscope.
    采用金相显微镜、扫描电子显微镜（SEM）研究Fe-Al金属间化合物复合涂层的组织。

noun

1. light microscope that has two converging lens systems: the objective and the eyepiece